Select Save settings to save the following settings to the memory card (if the card is full, an error will be displayed). Use this option to share settings among cameras of the same model.
Playback menu
Playback display options
Image review
After delete
After burst, show
Rotate tall
Photo shooting menu
File naming
Choose image area
Image quality
Image size
NEF (RAW) recording
ISO sensitivity settings
White balance
Set Picture Control (Custom Picture Controls are saved as Auto)
Color space
Active D-Lighting
Long exposure NR
High ISO NR
Vignette control
Diffraction compensation
Auto distortion control
Flicker reduction shooting
Metering
Flash control
Flash mode
Flash compensation
Focus mode
AF-area mode
Vibration reduction (settings vary with lens)
Auto bracketing
Silent photography
Movie shooting menu
File naming
Choose image area
Frame size/frame rate
Movie quality
Movie file type
ISO sensitivity settings
White balance
Set Picture Control (Custom Picture Controls are saved as Auto)
Active D-Lighting
High ISO NR
Vignette control
Diffraction compensation
Auto distortion control
Flicker reduction
Metering
Focus mode
AF-area mode
Vibration reduction (settings vary with lens)
Electronic VR
Microphone sensitivity
Attenuator
Frequency response
Wind noise reduction
Headphone volume
Timecode (excepting Timecode origin)
Custom Settings
All Custom Settings except d3 (Sync. release mode options)
Setup menu
Language
Time zone and date (excepting Date and time)
Limit monitor mode selection
Information display
Non-CPU lens data
Clean image sensor
Image comment
Copyright information
Beep options
Touch controls
HDMI
Location data (excepting Position)
Wireless remote (WR) options
Assign remote (WR) Fn button
Slot empty release lock
Settings saved using the camera or other cameras of the same model can be restored by selecting Load settings. Note that Save/load settings is only available when a memory card is inserted in the camera, and that the Load settings option is only available if the card contains saved settings.
Saved Settings
Settings are saved in a file with a name beginning with “NCSET” and ending with three characters that differ from camera to camera. The camera will not be able to load settings if the file name is changed.
